[simpits-tech] Image warping (Was: Frustration!)

[Cris Harrison]

On 2/22/2012 12:29 AM, dabigboy at cox.net wrote:
> ---- Cris Harrison<phoenixcomm at gmail.com>  wrote:
>> Matt
>> Your idea, with the analog port; it will not work.
>>
>> I have seen people tare up the radio head and change all the wiring (If
>> you really want to go through, and redesign the thing), when you have
>> the pin-out! just get a connector and build a nice cable.
> <snip>
>
> Hmmmm I think I see part of my problem...I saw the resistor pack on the whole digits and just assumed the actual radio was reading the resistance value based on frequency selection....but then there should only be two terminals for the whole digits, while clearly there are more.
>
> One of your diagrams just "clicked" for me now....by "2 of 5" you're saying that for one set of digits (tenths, for instance) there are 5 wires on the back of the Gables unit, and only two of those will be active at any given time? I think my particular unit uses one or two more wires, but I see what you're saying here. So my whole digits must be using the same kind of idea, I just didn't realize it at first.......so I'm guessing the resistors on the whole digits rotary switch are actually pull-down resistors? Hrrmm.....I am still a bit unclear, but the fog is slowly lifting. :)
Hay the fog has lifted... sorry bout the stick I was hitting you 
with...  so to some it up..
Each digit has 5 wires (bits) and only 2 of them will be low the other 3 
will be pulled up> :)
I found a video on you tube: 
http://www.youtube.com/watch?v=4skhmZhXjjo&feature=endscreen&NR=1 
<http://www.youtube.com/watch?v=4skhmZhXjjo&feature=endscreen&NR=1>

your right about the connectors... OUCH. ok look up Connector 
Distribution in LA check them out also them them that you dont care if 
its in plastic or if it scratched... I realy dont know what else you are 
going to use...
>
> I haven't hackerized the whole digits yet, perhaps I need to grab the multimeter and revisit them. Btw, the ONLY reason I am forced to cut into the wiring harness for the head is that the connectors are over $100 a piece....doesn't make much sense to spend $300+ for something that barely cost me $40. Even if I can make the original wiring scheme work, I will still have to cut into the wiring and use something other than the built-in connector. It does suck. :(
>
> Matt
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
>