[simpits-tech] Microstop....

[biggles]

RE: [simpits-tech] Microstop....Are the ones you talk about the ones from aerosource?
I resently obtained a set from them.
First class material, and not expensive.

Biggles.
  ----- Original Message ----- 
  From: Shira, Craig 
  To: Simulator Cockpit tech list 
  Sent: Monday, March 29, 2004 8:11 PM
  Subject: RE: [simpits-tech] Microstop....


  Yes, they can be. I can locate a set for you either new or used. 
  They are also on Ebay. 

  Craig 

  -----Original Message----- 
  From: simpits-tech-bounces at simpits.org 
  [mailto:simpits-tech-bounces at simpits.org]On Behalf Of Gene Buckle 
  Sent: Monday, March 29, 2004 12:10 PM 
  To: Simulator Cockpit tech list 
  Subject: RE: [simpits-tech] Microstop.... 



  > There are several different sizes of cutters. They are piloted type cutters 
  > to make holes for countersink fasteners. Some of the aviation sites are numbered 
  > 3, 4, 5, 6, 7, and 8. They are in 1/16 inch increments. Their range can be from 
  > .098 to .500. The cutter is chucked in a drill like a drill bit. The "Cage" can 
  > be rotated up or down to set the depth of the cut. There is a lock ring that is screwed 
  > against the cage to lock it in place. There are marks on the cage and the housing to 
  > monitor how many increments you have moved. I think they are in 1/32 increments. 
  > 
  > ****** You set you depth on a practice piece of material first. The same thickness 
  > as your project.******** 
  > 
  > The best way to check the depth of the cut is use the fastener you are going to use. 
  > Take your time. You cannot replace the material if you go too deep. 
  > 

  Thanks Craig.  Are they sold in sets? 

  g. 



  _______________________________________________ 
  Simpits-tech mailing list 
  Simpits-tech at simpits.org 
  http://www.simpits.org/mailman/listinfo/simpits-tech 
  To unsubscribe, please see the instructions at the bottom of the above page.  Thanks! 



------------------------------------------------------------------------------


  _______________________________________________
  Simpits-tech mailing list
  Simpits-tech at simpits.org
  http://www.simpits.org/mailman/listinfo/simpits-tech
  To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20040329/cf80be84/attachment-0001.html