[simpits-tech] Dzus layout drawing...
Erwin Neyt
erwin at sim-instruments.com
Tue Mar 23 19:40:27 PST 2004
Rene,
If you're interested, Pim has one you might want to check out.
Erwin.
_____
From: simpits-tech-bounces at simpits.org
[mailto:simpits-tech-bounces at simpits.org] On Behalf Of biggles
Sent: Tuesday, March 23, 2004 3:05
To: Simulator Cockpit tech list
Subject: Re: [simpits-tech] Dzus layout drawing...
David,
Is it possible to post a picture of the tool ?
Might be a way to make one myself ?
Or is it some kind of fancy technical devise ?
Thanks,
Biggles.
----- Original Message -----
From: Joseph <mailto:falcon4 at sbcglobal.net> Fagner
To: 'Simulator Cockpit tech list' <mailto:simpits-tech at simpits.org>
Sent: Tuesday, March 23, 2004 2:04 AM
Subject: RE: [simpits-tech] Dzus layout drawing...
So there is a special tool that presses those little quarter turn fastener
into the back plates, no?
This is good stuff, there's a bunch of us over at Viperpits getting plans
together to make our own back lit panels. What's the info I need on the
hole sizes and stuff like that? I already know the hole spacing, from this
discussion, but David, you were referring to a coutersind cage and piloted
cutter. What are those guys? I might get that myself and do all the holes
for the groups back plates.
Jay
-----Original Message-----
From: simpits-tech-bounces at simpits.org
[mailto:simpits-tech-bounces at simpits.org] On Behalf Of David C. Allen
Sent: Monday, March 22, 2004 5:01 PM
To: Simulator Cockpit tech list
Subject: Re: [simpits-tech] Dzus layout drawing...
At 03:33 PM 3/22/2004, you wrote:
> > >I'm not going to countersink the holes since I refuse to pay $300 for a
> > >very simple tool.
> >
> > Gene
> > You can buy a used Aircraft Microstop Countersink Cage and a new 100
degree
> > piloted cutter from Ray Lawrence, email RL100W at aol.com for around
$35.00.
> > Just get a piloted cutter for the .257 hole.
> >
>
>I was referring to the dzus press. Is that it?
Gene
No that was for the micro-stop and counter sink
But if you want to send me the Dzus fasteners and the panels, I will use my
Dzus tool and press them in for you.
David
>g.
>
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech at simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the above
>page. Thanks!
_______________________________________________
Simpits-tech mailing list
Simpits-tech at simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page.
Thanks!
_____
_______________________________________________
Simpits-tech mailing list
Simpits-tech at simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page.
Thanks!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20040323/bc5785d9/attachment.html
More information about the Simpits-tech
mailing list