[simpits-tech] Dzus layout drawing...

[biggles]

David,

Is it possible to post a picture of the tool ?
Might be a way to make one myself ?
Or is it some kind of fancy technical devise ?

Thanks,

Biggles.
  ----- Original Message ----- 
  From: Joseph Fagner 
  To: 'Simulator Cockpit tech list' 
  Sent: Tuesday, March 23, 2004 2:04 AM
  Subject: RE: [simpits-tech] Dzus layout drawing...


  So there is a special tool that presses those little quarter turn fastener into the back plates, no?

   

  This is good stuff, there's a bunch of us over at Viperpits getting plans together to make our own back lit panels.  What's the info I need on the hole sizes and stuff like that?  I already know the hole spacing, from this discussion, but David, you were referring to a coutersind cage and piloted cutter.  What are those guys?  I might get that myself and do all the holes for the groups back plates.

   

  Jay

   

  -----Original Message-----
  From: simpits-tech-bounces at simpits.org [mailto:simpits-tech-bounces at simpits.org] On Behalf Of David C. Allen
  Sent: Monday, March 22, 2004 5:01 PM
  To: Simulator Cockpit tech list
  Subject: Re: [simpits-tech] Dzus layout drawing...

   

  At 03:33 PM 3/22/2004, you wrote:

  > > >I'm not going to countersink the holes since I refuse to pay $300 for a

  > > >very simple tool.

  > >

  > > Gene

  > > You can buy a used Aircraft Microstop Countersink Cage and a new 100 degree

  > > piloted cutter from Ray Lawrence, email  RL100W at aol.com for around $35.00.

  > > Just get a piloted cutter for the .257 hole.

  > >

  > 

  >I was referring to the dzus press.  Is that it?

   

  Gene

  No that was for the micro-stop and counter sink

   

  But if you want to send me the Dzus fasteners and the panels, I will use my 

  Dzus tool and press them in for you.

   

  David

   

  >g.

  > 

  > 

  >_______________________________________________

  >Simpits-tech mailing list

  >Simpits-tech at simpits.org

  >http://www.simpits.org/mailman/listinfo/simpits-tech

  >To unsubscribe, please see the instructions at the bottom of the above 

  >page.  Thanks!

   

  _______________________________________________

  Simpits-tech mailing list

  Simpits-tech at simpits.org

  http://www.simpits.org/mailman/listinfo/simpits-tech

  To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!



------------------------------------------------------------------------------


  _______________________________________________
  Simpits-tech mailing list
  Simpits-tech at simpits.org
  http://www.simpits.org/mailman/listinfo/simpits-tech
  To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20040323/b80f74eb/attachment.html