[simpits-tech] Dzus layout drawing...
Marv De Beque
mdebeque at woh.rr.com
Mon Mar 22 17:22:35 PST 2004
That is one of the things I did in addition to measuring some real panels.
However, measuring things empirically can introduce errors, too! Since the
error is 0.010" it is wise to double check with a specification if possible.
Marv
On 3/22/04 2:51 PM, "Gene Buckle" <geneb at deltasoft.com> wrote:
> Thanks for the info Dave. Unfortunately, I don't have any mechanical
> drawings that cover the side consoles in the Eagle. Would measuring from
> retaining wire to retaining wire be good enough to tell me what the
> spacing is?
>
> tnx!
>
> g.
>
>
> On Mon, 22 Mar 2004, David C. Allen wrote:
>
>> Hi Gene
>> Look for the center to center specification of your Dzus mounting rails
>> that you are going to install the panels in. Sorry for the confusion but
>> unless we find a Mil-Spec or ATA Spec, all I have is this information:
>>
>> Here is a Real Life Panel Example for a 5.75 x 9.00 nominal panel.
>> Using the lower left hand corner as the controlling edges:
>>
>> Panel width from the Left controlling edge 5.750 +0.000 -0.020
>> Panel height from the Bottom controlling edge 9.000 +0.000 -0.041
>>
>> Dzus hole location: +/- .005"
>> 0.183 from the Left controlling edge to the first Dzus centerline
>> 5.548 from the Left controlling edge to the second Dzus centerline
>>
>> Nominal 5.365 between the first and second Dzus centerlines
>>
>> First & second Dzus centerline 0.554 up from the lower controlling edge
>>
>> The third and fourth Dzus centerline would be located 8.429 up from the
>> lower controlling edge.
>>
>> As you can see the "Top Edge" and "Right Edge" float with the tolerance.
>> The Dzus dimensions are held to +/- 005"
>>
>> David
>>
>> At 11:18 AM 3/22/2004, you wrote:
>>
>>> Ok, who's right? I gotta know for sure before I send off the data for
>>> metal plates to be drilled. :)
>>>
>>> g.
>>>
>>>
>>> _______________________________________________
>>> Simpits-tech mailing list
>>> Simpits-tech at simpits.org
>>> http://www.simpits.org/mailman/listinfo/simpits-tech
>>> To unsubscribe, please see the instructions at the bottom of the above
>>> page. Thanks!
>>
>> _______________________________________________
>> Simpits-tech mailing list
>> Simpits-tech at simpits.org
>> http://www.simpits.org/mailman/listinfo/simpits-tech
>> To unsubscribe, please see the instructions at the bottom of the above page.
>> Thanks!
>>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.
> Thanks!
More information about the Simpits-tech
mailing list