[simpits-tech] Dzus layout drawing...

[Erwin Neyt]

Maybe this helps....

Link: http://www.simpits.org/fileproc/dload.php?file=pr35.jpg

Erwin

> -----Original Message-----
> From: simpits-tech-bounces at simpits.org 
> [mailto:simpits-tech-bounces at simpits.org] On Behalf Of Gene Buckle
> Sent: Monday, March 22, 2004 20:51
> To: Simulator Cockpit tech list
> Subject: Re: [simpits-tech] Dzus layout drawing...
> 
> Thanks for the info Dave.  Unfortunately, I don't have any 
> mechanical drawings that cover the side consoles in the 
> Eagle.  Would measuring from retaining wire to retaining wire 
> be good enough to tell me what the spacing is?
> 
> tnx!
> 
> g.
> 
> 
> On Mon, 22 Mar 2004, David C. Allen wrote:
> 
> > Hi Gene
> > Look for the center to center specification of your Dzus mounting 
> > rails that you are going to install the panels in. Sorry for the 
> > confusion but unless we find a Mil-Spec or ATA Spec, all I 
> have is this information:
> >
> > Here is a Real Life Panel Example for a 5.75 x 9.00 nominal panel.
> > Using the lower left hand corner as the controlling edges:
> >
> > Panel width from the Left controlling edge 5.750 +0.000 
> -0.020 Panel 
> > height from the Bottom controlling edge 9.000 +0.000 -0.041
> >
> > Dzus hole location: +/- .005"
> > 0.183 from the Left controlling edge to the first Dzus centerline
> > 5.548 from the Left controlling edge to the second Dzus centerline
> >
> > Nominal  5.365 between the first and second Dzus centerlines
> >
> > First & second Dzus centerline 0.554 up from the lower controlling 
> > edge
> >
> > The third and fourth Dzus centerline would be located 8.429 up from 
> > the lower controlling edge.
> >
> > As you can see the "Top Edge" and "Right Edge" float with 
> the tolerance.
> > The Dzus dimensions are held to +/- 005"
> >
> > David
> >
> > At 11:18 AM 3/22/2004, you wrote:
> >
> > >Ok, who's right?  I gotta know for sure before I send off the data 
> > >for metal plates to be drilled. :)
> > >
> > >g.
> > >
> > >
> > >_______________________________________________
> > >Simpits-tech mailing list
> > >Simpits-tech at simpits.org
> > >http://www.simpits.org/mailman/listinfo/simpits-tech
> > >To unsubscribe, please see the instructions at the bottom of the 
> > >above page.  Thanks!
> >
> > _______________________________________________
> > Simpits-tech mailing list
> > Simpits-tech at simpits.org
> > http://www.simpits.org/mailman/listinfo/simpits-tech
> > To unsubscribe, please see the instructions at the bottom 
> of the above page.  Thanks!
> >
> 
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of 
> the above page.  Thanks!
>