[simpits-tech] Dzus layout drawing...

[Gene Buckle]

Thanks for the info Dave.  Unfortunately, I don't have any mechanical
drawings that cover the side consoles in the Eagle.  Would measuring from
retaining wire to retaining wire be good enough to tell me what the
spacing is?

tnx!

g.


On Mon, 22 Mar 2004, David C. Allen wrote:

> Hi Gene
> Look for the center to center specification of your Dzus mounting rails
> that you are going to install the panels in. Sorry for the confusion but
> unless we find a Mil-Spec or ATA Spec, all I have is this information:
>
> Here is a Real Life Panel Example for a 5.75 x 9.00 nominal panel.
> Using the lower left hand corner as the controlling edges:
>
> Panel width from the Left controlling edge 5.750 +0.000 -0.020
> Panel height from the Bottom controlling edge 9.000 +0.000 -0.041
>
> Dzus hole location: +/- .005"
> 0.183 from the Left controlling edge to the first Dzus centerline
> 5.548 from the Left controlling edge to the second Dzus centerline
>
> Nominal  5.365 between the first and second Dzus centerlines
>
> First & second Dzus centerline 0.554 up from the lower controlling edge
>
> The third and fourth Dzus centerline would be located 8.429 up from the
> lower controlling edge.
>
> As you can see the "Top Edge" and "Right Edge" float with the tolerance.
> The Dzus dimensions are held to +/- 005"
>
> David
>
> At 11:18 AM 3/22/2004, you wrote:
>
> >Ok, who's right?  I gotta know for sure before I send off the data for
> >metal plates to be drilled. :)
> >
> >g.
> >
> >
> >_______________________________________________
> >Simpits-tech mailing list
> >Simpits-tech at simpits.org
> >http://www.simpits.org/mailman/listinfo/simpits-tech
> >To unsubscribe, please see the instructions at the bottom of the above
> >page.  Thanks!
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
>