[simpits-tech] Dzus layout drawing...

[Gene Buckle]

> Hi Gene
> Measuring the wire to wire or hole to hole should tell you the average width.
>
> I would not loose any sleep over 5.375 or 5.365 it is only .010" and both
> will fit in the Eagle.
>
Ok.

> The smaller value 5.356 will allow you more metal between the OD of the 100
> degree Dzus countersink on the back side of the panel and the edge of the
> panel.
>
I'm not going to countersink the holes since I refuse to pay $300 for a
very simple tool.

g.