[simpits-tech] Dzus layout drawing...

[David C. Allen]

Hi Gene
Measuring the wire to wire or hole to hole should tell you the average width.

I would not loose any sleep over 5.375 or 5.365 it is only .010" and both 
will fit in the Eagle.

The smaller value 5.356 will allow you more metal between the OD of the 100 
degree Dzus countersink on the back side of the panel and the edge of the 
panel.

David

At 12:51 PM 3/22/2004, you wrote:
>Thanks for the info Dave.  Unfortunately, I don't have any mechanical
>drawings that cover the side consoles in the Eagle.  Would measuring from
>retaining wire to retaining wire be good enough to tell me what the
>spacing is?
>
>tnx!
>
>g.
>
>
>On Mon, 22 Mar 2004, David C. Allen wrote:
>
> > Hi Gene
> > Look for the center to center specification of your Dzus mounting rails
> > that you are going to install the panels in. Sorry for the confusion but
> > unless we find a Mil-Spec or ATA Spec, all I have is this information:
> >
> > Here is a Real Life Panel Example for a 5.75 x 9.00 nominal panel.
> > Using the lower left hand corner as the controlling edges:
> >
> > Panel width from the Left controlling edge 5.750 +0.000 -0.020
> > Panel height from the Bottom controlling edge 9.000 +0.000 -0.041
> >
> > Dzus hole location: +/- .005"
> > 0.183 from the Left controlling edge to the first Dzus centerline
> > 5.548 from the Left controlling edge to the second Dzus centerline
> >
> > Nominal  5.365 between the first and second Dzus centerlines
> >
> > First & second Dzus centerline 0.554 up from the lower controlling edge
> >
> > The third and fourth Dzus centerline would be located 8.429 up from the
> > lower controlling edge.
> >
> > As you can see the "Top Edge" and "Right Edge" float with the tolerance.
> > The Dzus dimensions are held to +/- 005"
> >
> > David
> >
> > At 11:18 AM 3/22/2004, you wrote:
> >
> > >Ok, who's right?  I gotta know for sure before I send off the data for
> > >metal plates to be drilled. :)
> > >
> > >g.
> > >
> > >
> > >_______________________________________________
> > >Simpits-tech mailing list
> > >Simpits-tech at simpits.org
> > >http://www.simpits.org/mailman/listinfo/simpits-tech
> > >To unsubscribe, please see the instructions at the bottom of the above
> > >page.  Thanks!
> >
> > _______________________________________________
> > Simpits-tech mailing list
> > Simpits-tech at simpits.org
> > http://www.simpits.org/mailman/listinfo/simpits-tech
> > To unsubscribe, please see the instructions at the bottom of the above 
> page.  Thanks!
> >
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech at simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the above 
>page.  Thanks!