[simpits-tech] DC voltage reduction

[Cris Harrison]

Justin a voltage divider will work but you need to the current that the
flag motor takes
vin -> R1 + R2 -> gnd
vout  from junction of R1 + R2
ohms law
E/(I * R)  if you know two you can solve for the other
enjoy
Cris H.
phoenixcomm.wordpress.com
www.phoenixaerospace.us
www.flite-tronics.com

and look at the BeagleBoard boots in to Linux... shit load of I/O


On Sun, Nov 11, 2012 at 10:16 PM, Justin Messenger <jjmessenger at yahoo.com>wrote:

> I need a way to lower and fine tune 3v dc from a pc power supply to pull ADI
> flags. How should I do this?
>
> Thanks
> Justin
>
>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page.  Thanks!
>



-- 





Please Note:
Any transactions over 1,000.00, or overseas transactions will be pre-paid
via Bank Wire only.
ALL VAT, Taxes and or shipping, custom charges will be paid by the customer.

Mobil    :       214-635-9818
Skype ID      Phoenixcomm
AIM - ICQ     194602804

We are what we repeatedly do. Excellence, therefore, is not an act, but a
habit.
Aristotle

www.phoenixcomm.net/~phnx2000/sim
www.phoenixtrading.biz / www.phoenixcomm.net / phoenixaerospace.us
Shipping / Billing Address: 921 Crawford Street, Suite 4207, Fort Worth,
Texas 76104 USA
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20121112/5b306fdb/attachment.html