[simpits-tech] bot fire...
Gene Buckle
geneb at deltasoft.com
Mon Jan 10 06:37:34 PST 2011
On Mon, 10 Jan 2011, Frank Riedel wrote:
> Hi G,
> What is your advice in cutting acrylic ??
> Cutter bit, spindel speed, cutter speed and depth ?
>
Frank, the last acrylic I machined was with a 1/4" "O" flute cutter @
10,000RPM with a feed rate of 1 inch/sec and a cut depth of 1/8" per pass.
Onsrud makes some very good "O" flute cutters specifically for machining
acrylic. Note that you'll get better results from cast acrylic as opposed
to extruded acrylic.
g.
--
Proud owner of F-15C 80-0007
http://www.f15sim.com - The only one of its kind.
http://www.simpits.org/geneb - The Me-109F/X Project
ScarletDME - The red hot Data Management Environment
A Multi-Value database for the masses, not the classes.
http://www.scarletdme.org - Get it _today_!
Political correctness is a doctrine, fostered by a delusional, illogical
minority, and rabidly promoted by an unscrupulous mainstream media, which
holds forth the proposition that it is entirely possible to pick up a turd
by the clean end.
More information about the Simpits-tech
mailing list