[simpits-tech] IFF panel...
Roy Coates
roy at flightlab.liv.ac.uk
Mon Aug 17 09:11:16 PDT 2009
On Mon, 17 Aug 2009, Gene Buckle wrote:
> > Drilled through? Tell me more ...
>
> Yep. If you look at some of the pictures, you can see that the wires pass
> completely through the female DB25 crimp connector. This allows you to
> route and tie all the wires properly before you crimp the pins on them. I
> cut one wire at a time flush with the top of the connector, pulled it out
> the back, stripped, crimped and installed in the new DB25 connector.
>
> To make the jig, just take a female DB25 crimp connector and using a drill
> bit that is as close to the large hole in the back as possible, drill
> through using a drill press. This will allow up to 22GA wire to pass
> through the connector.
Ah, useful!
Is that Nyvin you're using there ?
--
Roy Coates.
Dept of Engineering.
Liverpool University.
E-Mail: r.coates at liv.ac.uk
Tel: 0151 794 4862
-------------------------------------------------------------------------------
Lord, If I must have an instrument failure, please let it be the Hobbs meter.
-------------------------------------------------------------------------------
More information about the Simpits-tech
mailing list