[simpits-tech] Cutting thin materials.

[Ido Dekkers]

with or without a small hole in the middle ?

if you can live with a small hole in the middle :
use a circle cutter from NT cutters.

if not - i can only think of scissors.

Ido

On 10/4/07, Roy Coates <roy at flig htlab.liv.ac.uk> wrote:
>
>
>
> I'm sure other must have faced this... I hope.
>
> I need to cut very neat circles of about 50mm (2") diameter out of thin
> plasticard.
>
> How to do it?  Anyone got a super cool way of doing this?
>
> Thanks,
>
> Roy.
>
>
>
> --
>
> Roy Coates.
> Dept of Engineering.
> Liverpool University.
> E-Mail: r.coates at liv.ac.uk
> Tel: 0151 794 4862
>
> -------------------------------------------------------------------------------
> Lord, If I must have an instrument failure, please let it be the Hobbs
> meter.
>
> -------------------------------------------------------------------------------
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page.  Thanks!
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20071004/81542568/attachment.html