[simpits-tech] Slide potentiometers
John Miguez
jmiguez at bellsouth.net
Sun Nov 21 19:01:16 PST 2004
I think they are 50K pots? I looked at them once and considered
replacing them. Mouser has a 50K that will fit, however the slide
handle is a little different.
As I recall, Suncom was French. Pots are probably from Europe.
John
-----Original Message-----
From: Ed Henderson [mailto:aircop at comcast.net]
Sent: Sunday, November 21, 2004 10:41 AM
To: Simulator Cockpit tech list
Subject: Re: [simpits-tech] Slide potentiometers
Speaking of slide pots, I need to replace the ones in my Suncom
throttle. Has any one replaced the pots in a Suncom throttle? Part
numbers?
Thanks!
Ed
Matt Bailey wrote:
>Howdy,
>
> I just got some slide pots for flight controls (these:
http://www.mouser.com/index.cfm?handler=displayproduct&lstdispproductid=
210527&e_categoryid=316&e_pcodeid=03121 )
>but didn't notice until they arrived that they had four solder lugs.
I'm used to the 3-terminal kind. After checking with a multimeter, it
>looks like these have two grounds, sound right? So what exactly is the
"right" way to wire up these guys? Ground both terminals?
>
>Sorry for the dumb question, new territory for me. :)
>
> -Matt Bailey
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech at simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the above
page. Thanks!
>
>
>
More information about the Simpits-tech
mailing list