[simpits-tech] Microstop use...
Gene Buckle
geneb at deltasoft.com
Sat Nov 13 21:49:17 PST 2004
> Hi Gene
> Take a trip to Boeing Surplus and pick up a bunch of piloted 100 degree
> counter sinks. Then play around with some flat head rivets and flat head
> screws. The pilot diameter is normally the same size as your screw or rivet
> clearance hole diameter. If you are going to make some panels with Dzus
> fasteners you will need to counter sink the back side with a .257 piloted
> 100 degree countersink .
Ahh, so there _are_ threaded goodies that go into that thing. Tnx.
g.
--
"I'm not crazy, I'm plausibly off-nominal!"
Proud owner of 80-0007
http://www.f15sim.com - The only one of its kind.
More information about the Simpits-tech
mailing list