[simpits-tech] Microstop use...
David C. Allen
allendc at qwest.net
Sat Nov 13 22:30:24 PST 2004
Hi Gene
Take a trip to Boeing Surplus and pick up a bunch of piloted 100 degree
counter sinks. Then play around with some flat head rivets and flat head
screws. The pilot diameter is normally the same size as your screw or rivet
clearance hole diameter. If you are going to make some panels with Dzus
fasteners you will need to counter sink the back side with a .257 piloted
100 degree countersink .
You can also use it with threaded drill bits if you need to hand drill
perpendicular holes.
David
At 06:31 PM 11/10/2004, you wrote:
>I picked up a couple of nice looking Microstops on eBay this week, and now
>I need to know how they're used and what tools/bits screw into them. :)
>
>g.
>
>--
>"I'm not crazy, I'm plausibly off-nominal!"
>
>Proud owner of 80-0007
>http://www.f15sim.com - The only one of its kind.
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech at simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the above
>page. Thanks!
More information about the Simpits-tech
mailing list