[simpits-tech] Microstop....
Gene Buckle
geneb at deltasoft.com
Mon Mar 29 11:04:46 PST 2004
> I have four Microstops, each is setup with a piloted different cutter:
> Dzus countersink
> 8-32 100 degree Flathead screws
> 6-32 100 degree Flathead screws
> 2-56 100 degree Flathead screws
>
Are the 8-24 or 6-24 cutters different? Is 100 degrees the "common" angle
for what you'd typically buy from a bulk supplier like Lowe's?
> > How do you measure how deep the tool will go?
>
> I use a vernier caliper to measure the depth of the face of the screw or
> rivet below the surface.
>
------------- ------------+----
\ / |
\ / |X
| | ------------+----
Is this the measurement you're referring to?
g.
More information about the Simpits-tech
mailing list