[simpits-tech] Re: to ERWIN
Ido Dekkers
idekkers at clicksoftware.com
Wed Sep 24 10:36:57 PDT 2003
Hi Erwin
How hard will it be to add just the labels to the new exe now ?
at least we'll have some display on the mfd's ?
Ido
"Erwin Neyt"
<erwin at sim-instru
ments.com> To
Sent by: "Simulator Cockpit tech list"
simpits-tech-boun <simpits-tech at simpits.org>
ces at simpits.org cc
Subject
09/23/2003 22:20 Re: [simpits-tech] Re: to ERWIN
Please respond to
Erwin Neyt
<erwin at sim-instru
ments.com>;
Please respond to
Simulator Cockpit
tech list
<simpits-tech at sim
pits.org>
You know at one point (I think just before SP1 I did put the labels in
sh.mem) But I judged (very wrongly) I would get the full MFD support in
there short after, and I never submitted the code to F4UT. :(
After that the problem with DX7 started and I laid off my efforts to get
the
MFD's working.
Erwin.
----- Original Message -----
From: <pigi at frumar.it>
To: <simpits-tech at simpits.org>
Sent: Tuesday, September 23, 2003 10:02 AM
Subject: [simpits-tech] Re: to ERWIN
> I can understand that getting MFD data out of falcon could be a long job,
but I
> think that getting at least the OBS label would not be a so long job,
isnt'it
> ?
>
> This could lead to a display inside "a lot of switch" ....
> Can you (all) understand what I mean ;-) ?
>
> Pigi
>
> P.s.
> Erwin, I have a not-so-bad knowing of C programming, if you (or the
other)
need
> an hand....
> ( at least I better know C than english :) )
>
> ----------------------------------------------------------------
> This message was sent using IMP, the Internet Messaging Program.
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
page. Thanks!
_______________________________________________
Simpits-tech mailing list
Simpits-tech at simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above
page. Thanks!
More information about the Simpits-tech
mailing list