[simpits-tech] Cockpit Dimensions
simpits-tech@simpits.org
simpits-tech@simpits.org
Sat, 1 Mar 2003 14:20:14 EST
--part1_1a4.11518ccc.2b9261ee_boundary
Content-Type: text/plain; charset="US-ASCII"
Content-Transfer-Encoding: 7bit
although the motion base is a good idea however upon investigation if one was
to pay 50k for a 6 degree movement which is silly money it would more
prudent to concentrate on the visuals for fuller immersion being bold and as
to the completion of the pit as you are receiving in due coarse a full set of
working drawings may I suggest that you fabricate out of sheet metal the pit
itself it self as it is lighter and one at the same can add the leading edges
and raise it above floor level hence the climb in feel from inception just a
few ideas to consider
--part1_1a4.11518ccc.2b9261ee_boundary
Content-Type: text/html; charset="US-ASCII"
Content-Transfer-Encoding: quoted-printable
<HTML><FONT FACE=3Darial,helvetica><FONT SIZE=3D2 FAMILY=3D"SANSSERIF" FACE=
=3D"Arial" LANG=3D"0">although the motion base is a good idea however upon i=
nvestigation if one was to pay 50k for a 6 degree movement which is si=
lly money it would more prudent to concentrate on the visuals for fuller imm=
ersion being bold and as to the completion of the pit as you are receiving i=
n due coarse a full set of working drawings may I suggest that you fabricate=
out of sheet metal the pit itself it self as it is lighter and one at the s=
ame can add the leading edges and raise it above floor level hence the climb=
in feel from inception just a few ideas to consider </FONT></HTML>
--part1_1a4.11518ccc.2b9261ee_boundary--