[simpits-tech] Throttle Arm base dimensions

[Chris Crowley]

Thanks for the detail on the gear Martin! The space it occupies in the
console is pretty important to me. I am using it to calibrate the instrument
drawing from simpits and figure out how low to go with the base of the
cougar throttle. I hope it goes low enough to fit the instruments above :-).
I am planning on building a modified arm for it.

Chris Crowley


-----Original Message-----
From: simpits-tech-admin@simpits.org
[mailto:simpits-tech-admin@simpits.org]On Behalf Of F16
Sent: Wednesday, January 08, 2003 1:06 PM
To: 'simpits-tech@simpits.org'
Subject: AW: [simpits-tech] Throttle Arm base dimensions


Hello Chris,

the diameter of the friction control is 127,2mm (outside). The wheel has 36
teeth. The internal diameter is 17.6 mm. The thickness is 8 mm. The angle
from the throttle arm is backward 25 degrees and forward 37,25 degrees. And
- I am not sure - I think that the space between the consoles are 100mm.

Hope, its helpful for you
Martin "Pegasus"