[simpits-tech] Panel print-outs

[Frank Riedel]

Hi "Pegasus"
Are you still hanging around here ;o)
How is your new pit-building going ??

I'll expect mine to be completet after this week - except for the outer skin
and
i'm still waiting for the CubPilot HOTAS mod... it is on it's way ;o)


All the best
Frank



----- Original Message -----
From: "F16" <f16@xflight.de>
To: <simpits-tech@simpits.org>
Sent: Monday, April 14, 2003 9:42 PM
Subject: AW: [simpits-tech] Panel print-outs


> Hello Chris,
>
> all the panels are sitting in a DZUS-rail grid with a height of 9,525mm =
> 0,375" per screw and a width from 146,050mm = 57,5". Between two panels
are
> round about 2mm space. I have measure original panels and the width from
> most of this panels are between 143,8 and 145,7mm.
>
> The crazy factor from 103% are a problem from the scanned original layout.
> I have checked the dimensions of this plan with many original parts and I
> found a scale from 102,95%, that's round about 103%. A big problem of the
> original Lockheed plot was, that many parts of the plot have idealistic
> measurements. For example, the left and right console have not the
original
> dimensions, while the original console have a left/right angle from round
> about 10 degrees and a back/front angle from round about 5.5 degrees, and
> in the plot you have a total sight of top without this angles.
>
> Now, for me was it easier to make my panel drawings with 103% as to make
> the complete plot a little bit greater ;-)
>
> I hope, its helpfull for you.
> Martin "Pegasus"
>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
page.  Thanks!
>