[simpits-tech] panel material
Shira, Craig
simpits-tech@simpits.org
Wed, 25 Sep 2002 06:48:37 -0500
Hermes already makes a 2 colored plastic, white on the
inside, black on the outside. You then engrave only the
black, leaving the white.
-----Original Message-----
From: Marv De Beque [mailto:mdebeque@woh.rr.com]
Sent: Tuesday, September 24, 2002 5:04 PM
To: simpits-tech@simpits.org
Subject: Re: [simpits-tech] panel material
If you are talking about the light plates for the instrumentation that has
the switches and knobs, it is 1/4" clear acrylic cast panels.
You can use cast sheets and cut to size. Use water as a coolant to cut and
drill. Paint white, then black and engrave.
--
> From: dphens <dphens@nc.rr.com>
> Reply-To: simpits-tech@simpits.org
> Date: Tue, 24 Sep 2002 09:24:09 -0700 (PDT)
> To: simpits-tech@simpits.org
> Subject: [simpits-tech] panel material
>
> Hey guys,
>
> I am looking for something to use in duplicating a panel. Ideally, I would
> like a material that is about a 1/8" thick and white in color. My thought
is
> to paint the material and then engrave it to have white lettering and
> backlighting. I guess it would also need to be easily cut and drilled.
> Anyone know of something I could do that with?
>
> Thanks!
>
> Dave
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
page.
> Thanks!
_______________________________________________
Simpits-tech mailing list
Simpits-tech@simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page.
Thanks!