[simpits-tech] backlit panels 101
Wombat
simpits-tech@simpits.org
Sun, 29 Dec 2002 21:46:42 +1100
Ahh .. no problems. Won't make a difference.
Regards,
Joe
---------- Original Message ----------------------------------
From: Ido Dekkers <idekkers@clicksoftware.com>
Reply-To: simpits-tech@simpits.org
Date: Sun, 29 Dec 2002 12:39:10 +0200
>
>
>
>
>
>I was mainly worried about the threading for the screws ( that
connect the
>light plate) , if that will make a difference there
>
>Ido
>
>
>
>
Sean
>
Galbraith
>
<sean.g@pa To
> radise.net simpits-
tech@simpits.org
> .nz>
cc
> Sent
by:
> simpits-
te Subject
> ch-admin@s Re: [simpits-tech] backlit panels
101
>
impits.org
>
>
>
12/29/2002
> 12:28
PM
>
>
>
Please
> respond
to
> simpits-
te
>
ch@simpits
> .org
>
>
>
>
>
>
>At 12:07 PM 12/29/02 +0200, you wrote:
>>Thanks
>>
>>That's exactly what i needed.
>>Do you think using 1.4mm instead of 1.6 will make much
difference ? this
>is
>>the only thing i can get here.
>>
>>Thanks
>>
>>Ido
>
>I don't think it will make a difference, and chances are, 1.4 and
1.6 *are*
>
>the same stuff. We use a number of different materials, which
are all
>nominally 16 Gauge, but can measure out anywhere from 1.4 through
to 1.7,
>even though on paper "16 Gauge" is 1.6mm
>
>Reality check is; will you ever notice that it's 0.2mm under
size? Hell the
>
>paint will be thicker than that :) and by the time you have the
panel
>completed nobody will be looking at the ali plate ;-)
>
>
>Sean (who_plays_with_sheet_steel_for_a_living)
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech@simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the
above
>page. Thanks!
>
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech@simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the
above page. Thanks!
>