[simpits-tech] Angle off front console

[Marv De Beque]

I should add that the right panel split point is closer to the front than
the left panel.



On 12/8/02 9:10 AM, "Ido Dekkers" <idekkers@clicksoftware.com> wrote:

> 
> 
> 
> 
> 
> Hi marv,
> Is the rake there for both parts or just the front one ?
> and is it the same for the right side ?
> 
> Thanks
> 
> Ido
> 
> 
> 
>                  
>            Marv De
>            Beque 
>            <mdebeque@                                                 To
>            woh.rr.com         <simpits-tech@simpits.org>
>>                                                          cc
>            Sent by:
>            simpits-te                                            Subject
>            ch-admin@s         Re: [simpits-tech] Angle off front console
>            impits.org
>                  
>                  
>            12/08/2002
>            03:49 PM
>                  
>                  
>              Please
>            respond to
>            simpits-te
>            ch@simpits
>               .org
>                  
>                  
> 
> 
> 
> 
> True.  I have a set of real side consoles and they are "bent" up 5 degrees
> as well as a 5 degree rake or angle inward.
> 
> 
> On 12/8/02 8:09 AM, "Wombat" <joe@bosnjak.com> wrote:
> 
>> Hi all,
>> 
>> It's been a while since I been in contact. Currently working
>> throught the construction of the Dzus rails for the panels.
>> I have been told that the front part of the right and left consle
>> pane is raked 5 degres up. Can anyone confirm this.
>> 
>> Here is a pic of what i'm talking about.
>> 
>> Regards,
>> 
>> Joe [wombat] Bosnjak
>> email: joe@bosnjak.com
>> website: http://www.f-16cockpit.com
>> 
>> 
>> 
> 
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page.  Thanks!
> 
> 
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.
> Thanks!