[simpits-tech] Angle off front console
Marv De Beque
simpits-tech@simpits.org
Sun, 08 Dec 2002 17:50:23 -0500
Yes, the two are essentially mirror copies of each other and have the inward
slope or rake of 5 degrees on both halves (front and back).
The split point front to back is the point where the LRUs (Dzus panels)
change direction by rotating 90 degrees left.
On 12/8/02 9:10 AM, "Ido Dekkers" <idekkers@clicksoftware.com> wrote:
>
>
>
>
>
> Hi marv,
> Is the rake there for both parts or just the front one ?
> and is it the same for the right side ?
>
> Thanks
>
> Ido
>
>
>
>
> Marv De
> Beque
> <mdebeque@ To
> woh.rr.com <simpits-tech@simpits.org>
>> cc
> Sent by:
> simpits-te Subject
> ch-admin@s Re: [simpits-tech] Angle off front console
> impits.org
>
>
> 12/08/2002
> 03:49 PM
>
>
> Please
> respond to
> simpits-te
> ch@simpits
> .org
>
>
>
>
>
>
> True. I have a set of real side consoles and they are "bent" up 5 degrees
> as well as a 5 degree rake or angle inward.
>
>
> On 12/8/02 8:09 AM, "Wombat" <joe@bosnjak.com> wrote:
>
>> Hi all,
>>
>> It's been a while since I been in contact. Currently working
>> throught the construction of the Dzus rails for the panels.
>> I have been told that the front part of the right and left consle
>> pane is raked 5 degres up. Can anyone confirm this.
>>
>> Here is a pic of what i'm talking about.
>>
>> Regards,
>>
>> Joe [wombat] Bosnjak
>> email: joe@bosnjak.com
>> website: http://www.f-16cockpit.com
>>
>>
>>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page. Thanks!
>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.
> Thanks!