[simpits-tech] Press-N-Squeal PC Board Sheets
Marv De Beque
simpits-tech@simpits.org
Sun, 01 Dec 2002 16:34:26 -0500
I already cut the PCB to the right size and tried taping the film from the
reverse side. It still slides around.
I am looking at getting some photosensitive PCB and trying that method.
On 12/1/02 2:41 PM, "Gene Buckle" <geneb@deltasoft.com> wrote:
> I take it you didn't tape the material to the board? From what I've
> heard, that helps quite a bit.
>
> g.
>
>
> On Sun, 1 Dec 2002, Marv De Beque wrote:
>
>> I recently bought the Press-N-Peel PC Board film to try making some small
>> prototype boards.
>>
>> The bad news is that I was very underwhelmed with the results.
>>
>> The good news is that it only took about 5 minutes of working with the stuff
>> to realize that it was not going to work.
>>
>> The biggest problem is registering the film over the PCB. Once you get it
>> where you want it, applying the hot iron will move it where you don't want
>> it. However, it won't move until it has deposited 50% of the toner in one
>> spot and then finishes with the remainder smeared over a different spot.
>>
>> Neither spot is where I had intended it to go.
>>
>> Not sure if I want to explore the UV photo etch route or not.
>>
>> Marv
>>
>>
>> _______________________________________________
>> Simpits-tech mailing list
>> Simpits-tech@simpits.org
>> http://www.simpits.org/mailman/listinfo/simpits-tech
>> To unsubscribe, please see the instructions at the bottom of the above page.
>> Thanks!
>>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.
> Thanks!