[simpits-tech] Flap gauge
Matt Bailey
dabigboy at cox.net
Mon Jun 2 17:05:43 PDT 2014
On Mon, 2 Jun 2014 18:59:53 -0500
Matt Bailey <dabigboy at cox.net> wrote:
> Not exactly...keep in mind I don't have the schematic so I am just
> going off what I observe.
>
> To put the needle at any given point in its normal range of motion,
> one of the three inputs will have FULL reference voltage (so 5v, in my
> case), while the other two needles receive two different voltages
> that, when combined, should equal the reference voltage. So a signal
> might look like this:
>
> Input A: 5v (fixed for a given 90* range)
> Input B: 2v
> Input C: 3v
WHOOPS, correction....the line with Input A should read:
Input A: 5v (fixed for a given 120* range)
I am still in air-core mode. :P
--
Matt Bailey
Keeping It Real:
Sabreliner 60 Flight Simulator
Serial # 306-61 - N1JX
http://sabrelinersim.com
More information about the Simpits-tech
mailing list