[simpits-tech] Need some Serial Communications help....
raysot at comcast.net
raysot at comcast.net
Thu Mar 3 13:35:32 PST 2011
I had a feeling about the non-standard signals. I'm used to seeing:
____
CLK
____
Data
____
ETC....
..and also shifting in LSB first. Interesting...
----- Original Message -----
From: "Roberto Waltman" <fsim at rwaltman.com>
To: "Simulator Cockpit Builder's List" <simpits-tech at simpits.org>
Sent: Thursday, March 3, 2011 1:23:24 PM
Subject: Re: [simpits-tech] Need some Serial Communications help....
>> ....
>> So perhaps I need to reverse my data stream and send my MSB first?
>
> I believe so. Page 6 in the data sheet, immediately below Table-2:
>
> "The 12 bits are shifted into the device’s shift register MSB
> first using a SPI compatible scheme."
By the way, this is not standardized. The MSB-LSB order, clock phase,
transfer length, etc., change from one SPI device to another.
Things can get complicated when you have multiple devices connected to the
same SPI bus, and you need to continuously reprogram your controller when
switching from one device to another.
_______________________________________________
Simpits-tech mailing list
Simpits-tech at simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page. Thanks!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20110303/7702bd25/attachment.html
More information about the Simpits-tech
mailing list