[simpits-tech] Phidgets for sale?
Cris Harrison
phoenixcomm at gmail.com
Sat Jul 16 07:00:37 PDT 2011
On 7/15/2011 6:03 PM, Roy Coates wrote:
> On 15 July 2011 18:50, <dabigboy at cox.net <mailto:dabigboy at cox.net>> wrote:
>
> Ahh yes, a Traumahawk. From your instrument description, I'm
> guessing you are using "hacked" servos and potentiometers to
> measure the position of needles that need more than the meager
> 180* or so that servos usually provide?
>
>
> Correct! I'm using Phidget servo drivers to make em move, and Bodnar
> boards to read the positions.
>
> I'm facing the same situation, but I recently found out about
> winch servos that do 2, 4, or even 8 full turns before stopping.
> The main problem is acquiring them, the only small ones I found
> are Chinese specials (ostensibly GWS) on ebay for around $30.
> If/when I can get some, this will probably be my route. Of course
> for non-limited instruments like the HSI and (sorta) the
> altimeter, I'll need to use geared steppers, or just stick with my
> current glass-cockpit setup for these instruments. My only "real"
> instruments at the moment are the airspeed indicator and the turn
> coordinator, the latter being from a real plane.
>
>
> Winch servo's are fairly cheap over here if memory serves but talking
> to my local RC shop guru, something he said put me off using them.
> Damned if I can remember what it was though :(
>
> With free access to rapid prototyping gear though, it's relatively
> painless for us to make custom stuff and the simpler gauges like RPM,
> Turn/Slip, Vacuum et al will be made in-house in ABS. I'll post pic's
> as they progress.
>
> Just ordered a Butt-Kicker too for some subtle 'feeling' in the
> cockpit. This is in addition to a powerful sub-woofer bolted under
> the seat ;-)
>
> The list so far...
>
> 2 Bodnar boards (pitch/roll/yaw/throttle/trim/carb
> heat/mixture/flaps/read servo pos/switches)
> 2 Phidget servo boards (to drive instrument servos)
> 2 Phidget Analogue-4 boards (to drive real gauges such as fuel qty,
> oil temp etc)
> 1 Phidget Interface Kit (starter engaged light/tpndr ident light/etc)
> 3 GoFlight panels (most cost-effective solution I could find)
Why dont you buy your radios from ebay?? most of them use ARINC410 2 of
5 code..
(http://phoenixcomm.wordpress.com/projects/airinc-410/)
> 1 Bendix King KT96 (dead, gutted, lights up and Ident button/light works)
>
> Roy.
>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page. Thanks
Regards
Cris H.
phoenixcomm.net/phnx2000/sim
phoenixcomm.wordpress.com
Enjoy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20110716/d8d6b580/attachment.html
More information about the Simpits-tech
mailing list