[simpits-tech] Arduino?
raysot at comcast.net
raysot at comcast.net
Thu Feb 10 18:51:47 PST 2011
Yep... just found it....
Serial.Read();
:-)
It's back on!
----- Original Message -----
From: "Gene Buckle" <geneb at deltasoft.com>
To: "Simulator Cockpit Builder's List" <simpits-tech at simpits.org>
Sent: Thursday, February 10, 2011 6:12:58 PM
Subject: Re: [simpits-tech] Arduino?
On Thu, 10 Feb 2011, raysot at comcast.net wrote:
>
>
>
> The card is installed and I have to Arduino software libraries installed
> and a basic project loaded to make an LED blink. It can blink like
> there's no tomorrow (5ms crest/valley 50% duty cycle) My interface to
> the aircores will be via the CS8190 Pulse to SOS/COS driver IC. (Much
> like a tach)
>
> The problem is, I see no way to integrate the FSUIPC libraries to the
> Arduino Development Environment, and likewise, no way to integrate the
> Arduino Libraries to something Like Visual Studio.
>
> So far all I can do is create/load a Sketch file onto the card and
> change the blink rate.
>
> Even if I used a H-Bridge IC to drive the aircores... How could I send
> FSUIPC data to the card? I'll drop by the Arduino forums as well....
Ray, you'll do it serially. The FTDI serial chip on the Arduino board
will have a 0% error rate at a 250,000 bits per second data rate.
You'll write FSUIPC code to pump data to the Arduino - that's what I do
for the light driver I did.
g.
--
Proud owner of F-15C 80-0007
http://www.f15sim.com - The only one of its kind.
http://www.simpits.org/geneb - The Me-109F/X Project
ScarletDME - The red hot Data Management Environment
A Multi-Value database for the masses, not the classes.
http://www.scarletdme.org - Get it _today_!
Political correctness is a doctrine, fostered by a delusional, illogical
minority, and rabidly promoted by an unscrupulous mainstream media, which
holds forth the proposition that it is entirely possible to pick up a turd
by the clean end.
_______________________________________________
Simpits-tech mailing list
Simpits-tech at simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page. Thanks!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20110211/54afdd69/attachment-0001.html
More information about the Simpits-tech
mailing list