[simpits-tech] Multiple windows in FS9

[delor lauchang]

Hi Frank,

used it before and it did not give the desired frame rate of at least 15fps.

used my two dual dvi 512 video card for the outside view, the frame
rate reliever FS9CFG I got from Simviation, improved my frame rate, Iam even
getting 20fps at ground and 28fps flying, no stutters or latency.

On Mon, May 18, 2009 at 8:58 AM, Frank Riedel <frank at rezultat.dk> wrote:

>  Hi Delor
>
>
> Are you using 2 MT2G on this setup ???
> or only 1 for the OTW ??
>
> Frank
>
>
>  ------------------------------
>
> *Fra:* simpits-tech-bounces at simpits.org [mailto:
> simpits-tech-bounces at simpits.org] *På vegne af *delor lauchang
> *Sendt:* 18. maj 2009 14:51
> *Til:* Simulator Cockpit Builder's List
> *Emne:* [Spam] Re: [simpits-tech] Multiple windows in FS9
>
>
>
> hi,
>
> have the set-up then save, before you start flying, and use that as your
> default start.
>
>
>
> for fs2004, you can use view option to assign your views, my forward left
> panel as view1, forward panel as view2, forward right panel view3, my lower
> panel for instruments as view0. you can either use cockpit or virtual view.
>
>
>
> for fsx, you do it a you as you are doing it now.
>
>
>
> thats how i configure my set up, iam using 32" for my panel, and three 22"
> for my views, two auxillary 7" on my left and right instruments as my nav
> and gps, all LCD's.
>  i have three 512 pci-x16 double dvi ATI radeon video card with dual athlon
> 64 AMD with 4gb of ram and almost no latency or stutters.
>
>
>
> and before i forget i also used the frame rate enhancer FS9CFG, not the
> default FS9CFG.
>
> On Sun, May 17, 2009 at 8:49 PM, Justin Messenger <jjmessenger at yahoo.com>
> wrote:
>
>
> Im experimenting with a Matrox TripleHead2Go and projectors. I am using 3
> windows rather than 1 wide one. Two windows are for the right and left
> views. Since the normal views only snap to ther right and left as long as
> you hold the view key down I used the virtual cockpit view and panned it to
> the position I wanted, then saved the flight. Here is the problem, when I
> reset the flight or leave FS and restart the program the views open ahowing
> the forward facing position. So*  have 3 views showing straight forward
> and I have to manual pan the right and left view every time. *How do I
> save a flight where the side views stay where I want them?
>
>
>
> Thx.
>
>       Justin Messenger
>
> Simulator Fly-Off Coordinator
>
> -----------------------------------
>
> Grasshopper Festival
>
> Augusta Sunrise Parade
>
> Kansas Museum of Military History
>
> Cell (501) 620-6004
>
> www.KMMH.org <http://www.kmmh.org/>
>
> http://www.downtownaugustainc.com/
>
>
>
>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page.  Thanks!
>
>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page.  Thanks!
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20090518/1075ff22/attachment.html