[simpits-tech] Cutting thin materials.

[Ido Dekkers]

here you can find these in graphic and arts stores.

Ido

On 10/4/07, Roy Coates <roy at flightlab.liv.ac.uk> wrote:
>
> On Thu, 4 Oct 2007, Gene Buckle wrote:
>
> > > I need to cut very neat circles of about 50mm (2") diameter out of
> thin
> > > plasticard.
> >
> > How thick is the material?
>
> About 1mm.
>
>
> > If you can't find anything to do it, send it my way and I'll run 'em
> through the laser.
>
> show off !  ;-)
>
>
>
>
> --
>
> Roy Coates.
> Dept of Engineering.
> Liverpool University.
> E-Mail: r.coates at liv.ac.uk
> Tel: 0151 794 4862
>
> -------------------------------------------------------------------------------
> Lord, If I must have an instrument failure, please let it be the Hobbs
> meter.
>
> -------------------------------------------------------------------------------
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page.  Thanks!
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20071004/a35652e4/attachment.html