[simpits-tech] Problem update & shop news...

[Ben Jones]

I'd reply but it prob wont get thru 8-)

Ben

----- Original Message ----- 
From: "Gene Buckle" <geneb at deltasoft.com>
To: <simpits-tech at simpits.org>
Sent: Tuesday, November 14, 2006 1:31 AM
Subject: [simpits-tech] Problem update & shop news...


>I replaced the defective DSL router with a new unit last night.  So far it
> hasn't stopped passing traffic like the old one did.
>
> There are still outstanding routing issues to and from simpits.org.  My
> ISP is currently trying to discover what they mis-configured. :)
>
> The heater was finally installed in the shop yesterday!  No more freezing
> fingers. :)  For those interested, it's a 75,000 BTU Cayenne brand LP Gas
> heater.  It draws combustion air from the outside so I don't have to worry
> about it igniting any chemical fumes in the air.
>
> I got the Epilog laser unpacked and set up on Saturday night.  Amazing
> little toy to say the least! It's treated just like a printer - in fact,
> you install a printer driver to talk to the laser.  Pretty cool stuff.
>
> I only did a few test runs with it by raster engraving some of the sample
> material that was included with it.  It's got a pretty steep learning
> curve to it as nothing is absolute because of differing material
> densities.  I should be able to get some great results out of it soon.
> This of course means that once I have a process in place, I'll be able to
> create Type 5 & Type 7 panels with no problems.  Not to mention the cool
> component parts for R/C models I'll be able to churn out. :)
>
> ttyl!
>
> g.
>
>
>
> -- 
> "I'm not crazy, I'm plausibly off-nominal!"
>
> Proud owner of 80-0007
> http://www.f15sim.com - The only one of its kind.
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above 
> page.  Thanks!
>