[simpits-tech] throttle reverse position

[David C. Allen]

Justin
The deadband is set from just a tad forward of the idle aft stop to 
the reverser deployed idle position.

This way engines remain at idle, during the transition from fwd 
thrust idle to the reverser deployed idle position of the thrust lever.

David

At 10:53 AM 8/7/2006 -0700, you wrote:
>David,
>It sounds like the registered version of FSUIPC is the
>solution. Due to the design of the throttles I cannot
>use two pots per engine to activate reversers, but for
>information sake, how is that done?
>
>Justin
>____________________________________________________
>Hi Justin
>Sounds like the way the 737 Thrust reversers work.
>
>If you use one pot then Full Reverse is 0 ohms, Idle
>is some percent
>of the pot travel, and Full forward thrust is 100% pot
>travel.
>
>Then you assign a dead band around Idle position using
>your analog
>interface software or FSUIPC.
>
>David
>www.737FlightSim.com
>
>
>  Douglas DC-8
>   www.dc8cockpit.catisp.com
>
>
>
>__________________________________________________
>Do You Yahoo!?
>Tired of spam?  Yahoo! Mail has the best spam protection around
>http://mail.yahoo.com
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech at simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the 
>above page.  Thanks!