[simpits-tech] Driving LED's form the parallel port (?)

[Stig Jørgensen]

Ok - for us that normaly speak english; wft is a step drill? Could you please provide a link with a picture?

Cheers

/Stig

-----Original Message-----
From: simpits-tech-bounces at simpits.org [mailto:simpits-tech-bounces at simpits.org] On Behalf Of Roy Coates
Sent: 2. november 2004 18:30
To: Simulator Cockpit tech list
Subject: Re: [simpits-tech] Driving LED's form the parallel port (?)

On Tue, 2 Nov 2004, Matt Bailey wrote:

> > If you're cutting holes up to about an inch, invest in a good step drill.
> > Thats the only way to cut neat holes in sheet.
>
> 	Heh, thanks for the tip, I'll have to take this up with my wallet. ;)
>

My current one cost me about 20 quid - worth every penny. Works a treat
with alloys and plastics too.


--

Roy Coates.
Dept of Engineering.
Liverpool University.
E-Mail: r.coates at liv.ac.uk
Tel: 0151 794 4862

_______________________________________________
Simpits-tech mailing list
Simpits-tech at simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!