[simpits-tech] Microstop....

[Shira, Craig]

Yes, they can be. I can locate a set for you either new or used.
They are also on Ebay.

Craig

-----Original Message-----
From: simpits-tech-bounces at simpits.org
[mailto:simpits-tech-bounces at simpits.org]On Behalf Of Gene Buckle
Sent: Monday, March 29, 2004 12:10 PM
To: Simulator Cockpit tech list
Subject: RE: [simpits-tech] Microstop....


> There are several different sizes of cutters. They are piloted type cutters
> to make holes for countersink fasteners. Some of the aviation sites are numbered
> 3, 4, 5, 6, 7, and 8. They are in 1/16 inch increments. Their range can be from
> .098 to .500. The cutter is chucked in a drill like a drill bit. The "Cage" can
> be rotated up or down to set the depth of the cut. There is a lock ring that is screwed
> against the cage to lock it in place. There are marks on the cage and the housing to
> monitor how many increments you have moved. I think they are in 1/32 increments.
>
> ****** You set you depth on a practice piece of material first. The same thickness
> as your project.********
>
> The best way to check the depth of the cut is use the fastener you are going to use.
> Take your time. You cannot replace the material if you go too deep.
>

Thanks Craig.  Are they sold in sets?

g.


_______________________________________________
Simpits-tech mailing list
Simpits-tech at simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20040329/f1a00e23/attachment.html