[simpits-tech] Dzus layout drawing...
David C. Allen
allendc at qwest.net
Mon Mar 22 16:00:46 PST 2004
At 03:33 PM 3/22/2004, you wrote:
> > >I'm not going to countersink the holes since I refuse to pay $300 for a
> > >very simple tool.
> >
> > Gene
> > You can buy a used Aircraft Microstop Countersink Cage and a new 100 degree
> > piloted cutter from Ray Lawrence, email RL100W at aol.com for around $35.00.
> > Just get a piloted cutter for the .257 hole.
> >
>
>I was referring to the dzus press. Is that it?
Gene
No that was for the micro-stop and counter sink
But if you want to send me the Dzus fasteners and the panels, I will use my
Dzus tool and press them in for you.
David
>g.
>
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech at simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the above
>page. Thanks!
More information about the Simpits-tech
mailing list