[simpits-tech] Screw question

[Marc Quintin]

Thanks Marv for your input

Marc..


>From: Marv De Beque <mdebeque at woh.rr.com>
>Reply-To: Simulator Cockpit tech list <simpits-tech at simpits.org>
>To: Simulator Cockpit tech list <simpits-tech at simpits.org>
>Subject: Re: [simpits-tech] Screw question
>Date: Thu, 18 Mar 2004 12:17:56 -0500
>
>That is the SAE thread size.  A Drill/Tap chart will reveal hole sizes for
>tapping.  Material type and thickness impact the actual pre tap hole size,
>but as a general rule it is valid.
>
>Marv
>
>
>On 3/18/04 12:01 PM, "Marc Quintin" <marcquintin at hotmail.com> wrote:
>
> > Guys, I'm about to order a box of screws and before I do, the number for 
>the
> > diameter of the screw represent what? I know the smaller the number, the
> > smaller the diameter but how do you calculate the diameter of let say a
> > screw that as the diameter of 4
> >
> > Thanks, Marc..
> >
> > _________________________________________________________________
> > Tired of spam? Get advanced junk mail protection with MSN Premium
> > 
>http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http:
> > //hotmail.com/enca&HL=Market_MSNIS_Taglines
> >
> > _______________________________________________
> > Simpits-tech mailing list
> > Simpits-tech at simpits.org
> > http://www.simpits.org/mailman/listinfo/simpits-tech
> > To unsubscribe, please see the instructions at the bottom of the above 
>page.
> > Thanks!
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech at simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the above 
>page.  Thanks!

_________________________________________________________________
http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines