[simpits-tech] Re:help needed on wiring up switches via a saitek
joystick
RickInNoCal at aol.com
RickInNoCal at aol.com
Mon Jun 14 03:06:38 PDT 2004
In a message dated 6/13/04 10:54:55 PM Pacific Daylight Time,
Steverdiamond at aol.com writes:
> hi guys,im starting to test out some panel switches,one strange one,?ive
> wired in the landing lights to the saitek board (one of the push buttons)it
> works ok going on,but to turn it off in have to turn it off,then on again????im
> gonna get a keyboard encoder soon so this will solve it,but wondered if
> anyone can shed any light,the start switches are wired in to another button and
> work just fine
When you turn on a switch connected to a button, you send a 'make' signal to
the computer. usually a light switch for a sim is a on/off toggle. If you
imagine you were still using a keyboard, you'd hit say the "L" key to turn the
lights on, and hit "L" again to turn them off. That's what you're doing by
turning the switch off then back on - sending another keypress.
If you can use FSUIPC you can change the commands to have turning it on send
a "lights on" signal, and have turning it off send a "lights off" signal.
Richard
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.simpits.org/pipermail/simpits-tech/attachments/20040614/cd96ff72/attachment.html
More information about the Simpits-tech
mailing list