[simpits-tech] Power Supply

[Robert Bibber]

It was working fine when I pulled it from the PC.

Rob Bibber
Karob Siberian Sleddogs
http://www.karobsiberians.com
----- Original Message ----- 
From: "Gene Buckle" <geneb at deltasoft.com>
To: "Simulator Cockpit tech list" <simpits-tech at simpits.org>
Sent: Wednesday, September 24, 2003 1:58 PM
Subject: Re: [simpits-tech] Power Supply


> Are you sure this power supply isn't damaged in some way?
> 
> g.
> 
> 
> On Wed, 24 Sep 2003, Robert Bibber wrote:
> 
> > EXACTLY
> >
> > Rob Bibber
> > Karob Siberian Sleddogs
> > http://www.karobsiberians.com
> > ----- Original Message -----
> > From: "Stig Joergensen" <stig.joergensen at clearsky.dk>
> > To: "Simulator Cockpit tech list" <simpits-tech at simpits.org>
> > Sent: Wednesday, September 24, 2003 1:43 PM
> > Subject: RE: [simpits-tech] Power Supply
> >
> >
> > You did place the resistor betwwen pwrgood and ground and then tapped
> > the pson to ground?
> >
> > /Stig
> >
> >
> > > -----Original Message-----
> > > From: Robert Bibber [mailto:robert at karobsiberians.com]
> > > Sent: 24. september 2003 19:39
> > > To: Simulator Cockpit tech list
> > > Subject: Re: [simpits-tech] Power Supply
> > >
> > >
> > > OK, I found a resistor on an old circuit board - used
> > > soldering iron to very gently remove it, hooked it up - still
> > > NADT! (Not A Damn Thing)
> > >
> > > Then -- oops! I dropped the resistor - where did it go? Damn!
> > > Those things are tiny!
> > >
> > > :-)
> > >
> > >
> > > Rob Bibber
> > > Karob Siberian Sleddogs
> > > http://www.karobsiberians.com
> > > ----- Original Message -----
> > > From: "Stig Joergensen" <stig.joergensen at clearsky.dk>
> > > To: "Simulator Cockpit tech list" <simpits-tech at simpits.org>
> > > Sent: Wednesday, September 24, 2003 1:15 PM
> > > Subject: RE: [simpits-tech] Power Supply
> > >
> > >
> > >
> > > A resistor is typical a round thingie with color marks expressing the
> > > value
> > >
> > >
> > > Found this site with google :
> > >
> > > http://www.jct.ac.il/electronics/webprogs/resistor/resistor.html
> > >
> > >
> > > /Stig
> > >
> > >
> > > > -----Original Message-----
> > > > From: Robert Bibber [mailto:robert at karobsiberians.com]
> > > > Sent: 24. september 2003 19:08
> > > > To: Simulator Cockpit tech list
> > > > Subject: Re: [simpits-tech] Power Supply
> > > >
> > > >
> > > > I'm still pretty new to this electronics stuff :-(
> > > > What does a 1k ohm resistor look like? I might be able to
> > > > borrow one from old junk.
> > > >
> > > > Rob Bibber
> > > > Karob Siberian Sleddogs
> > > > http://www.karobsiberians.com
> > > > ----- Original Message -----
> > > > From: "Stig Joergensen" <stig.joergensen at clearsky.dk>
> > > > To: "Simulator Cockpit tech list" <simpits-tech at simpits.org>
> > > > Sent: Wednesday, September 24, 2003 12:54 PM
> > > > Subject: RE: [simpits-tech] Power Supply
> > > >
> > > >
> > > > Try to load the PWRGOOD with a resistance (a 1k ohm should od
> > > > the trick)
> > > > connected to ground
> > > >
> > > > /Stig
> > > >
> > > >
> > > > > -----Original Message-----
> > > > > From: Gene Buckle [mailto:geneb at deltasoft.com]
> > > > > Sent: 24. september 2003 18:51
> > > > > To: Simulator Cockpit tech list
> > > > > Subject: Re: [simpits-tech] Power Supply
> > > > >
> > > > >
> > > > > > I connect PWRGOOD to Ground and nothing happens. I
> > > connect PSON to
> > > > > > ground and the fan spins for half a second then stops.
> > > I've tried
> > > > > > various combinations with no effect.
> > > > > >
> > > > > That's weird.  Plug something into the drive connectors so
> > > > > the supply will
> > > > > have a load on it and then try turning it on again.  That's
> > > > > the only thing
> > > > > I can think of - it's shutting down due to lack of a load.
> > > > >
> > > > > g.
> > > > >
> > > > > _______________________________________________
> > > > > Simpits-tech mailing list
> > > > > Simpits-tech at simpits.org
> > > > > http://www.simpits.org/mailman/listinfo/simpits-tech
> > > > > To unsubscribe, please see the instructions at the bottom of
> > > > > the above page.  Thanks!
> > > > >
> > > > _______________________________________________
> > > > Simpits-tech mailing list
> > > > Simpits-tech at simpits.org
> > > > http://www.simpits.org/mailman/listinfo/simpits-tech
> > > > To unsubscribe, please see the instructions at the bottom of
> > > > the above page.  Thanks!
> > > >
> > > >
> > > > _______________________________________________
> > > > Simpits-tech mailing list
> > > > Simpits-tech at simpits.org
> > > > http://www.simpits.org/mailman/listinfo/simpits-tech
> > > > To unsubscribe, please see the instructions at the bottom of
> > > > the above page.  Thanks!
> > > >
> > > _______________________________________________
> > > Simpits-tech mailing list
> > > Simpits-tech at simpits.org
> > > http://www.simpits.org/mailman/listinfo/simpits-tech
> > > To unsubscribe, please see the instructions at the bottom of
> > > the above page.  Thanks!
> > >
> > >
> > > _______________________________________________
> > > Simpits-tech mailing list
> > > Simpits-tech at simpits.org
> > > http://www.simpits.org/mailman/listinfo/simpits-tech
> > > To unsubscribe, please see the instructions at the bottom of
> > > the above page.  Thanks!
> > >
> > _______________________________________________
> > Simpits-tech mailing list
> > Simpits-tech at simpits.org
> > http://www.simpits.org/mailman/listinfo/simpits-tech
> > To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
> >
> > _______________________________________________
> > Simpits-tech mailing list
> > Simpits-tech at simpits.org
> > http://www.simpits.org/mailman/listinfo/simpits-tech
> > To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
> >
> 
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
>