[simpits-tech] Power Supply

[Robert Bibber]

So if I connect PWRGOOD to COMMON and PSON to ground it should work?
Rob Bibber
Karob Siberian Sleddogs
http://www.karobsiberians.com
----- Original Message ----- 
From: "Heidner, Troy W" <theidner at ku.edu>
To: "'Simulator Cockpit tech list'" <simpits-tech at simpits.org>
Sent: Wednesday, September 24, 2003 11:26 AM
Subject: RE: [simpits-tech] Power Supply


> 
>  
> > When plugged in, the only pin with power is #11 (PSON). I 
> > tried connecting this to pin #5 (PWRGOOD) with no results. No 
> > other pin has power. (I have to do this stuff here at work 
> > because I FRIED my multitester at home and they have a NICE 
> > one here!).
> 
> The trouble here is that the PWRGOOD line needs to be grounded, not set to
> +5v.  The PWRGOOD line is on pin #14 on a standard ATX powersupply and the
> line is usually green.  It needs to be grounded which can be accomplished
> jumping it to any of the following pins 3,5,7,13,15,16, or 17.  These lines
> are usually black.
> 
> The pins on the standard connector are numbered clockwise starting with pin
> 1 which is usually a yellow line.  It would be in the upper left corner if
> you are looking at the end of the connector laying horizontally with the
> clip down.
> 
> Hope that helps!
> 
> Troy
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!
>