[simpits-tech] Tech Help Needed: Aircraft Power

[Marvin Maxson]

Another idea, is one we used to use on the old Phantom. When we had a system
that was no longer installed, we would use a wire tie. You pull the breaker,
and wrap the wire tie around the CB and trim off the excess. This worked
pretty good for example when I was stationed at Luke AFB, our old C models
had the ECM system removed and ballast installed and the breakers
"collared". Then if you need to you can always cut the wiretie and reset as
needed. Just a thought.

Max

----- Original Message -----
From: "Gene Buckle" <geneb@deltasoft.com>
To: <simpits-tech@simpits.org>
Sent: 18 August, 2003 19:51
Subject: RE: [simpits-tech] Tech Help Needed: Aircraft Power


> > > Have you tried isolating the systems you don't want powered up by
> > > pulling the relevant circuit breakers?
> >
> > I can't rely on that, with the breakers located either side of the
> > flight-deck entrance it would be too easy for someone to accidnetally
push
> > one or more back in.
> >
> I'd put keeper clips on the breaker shaft and cover them with a clear
> sheet of plexiglass.
>
> g.
>
>
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
page.  Thanks!
>
>