[simpits-tech] new cockpit pics

[Mike Williams]

thanks,
I use Ramas graphics from the website, use Gerbview
http://www.softwarecompanions.com/ to print them in poster mode,you could
also use TurboCad or Autocad to postermode them too (I think) it will print
the graphics across
several sheets of 8.5x11 sheets, I used 3m spray glue on the backs applied
them, the sparayed 2 clear coats of enamel over the top of them, then use
800 grit or coarse steel woll to dull the gloss.

-----Original Message-----
From: simpits-tech-admin@simpits.org
[mailto:simpits-tech-admin@simpits.org]On Behalf Of Roy Coates
Sent: Thursday, September 26, 2002 8:26 PM
To: simpits-tech@simpits.org
Subject: Re: [simpits-tech] new cockpit pics


On Thu, 26 Sep 2002, Mike Williams wrote:


Looking good, Brian - and a question for you. How did you do the graphics
on the fuselage? (Rescue etc).  I never did find an acceptable method.

Cheers,

Roy.


_______________________________________________
Simpits-tech mailing list
Simpits-tech@simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page.
Thanks!