[simpits-tech] High speed steel drill
Marv De Beque
simpits-tech@simpits.org
Fri, 20 Sep 2002 06:40:12 -0400
Okay. Didn't know you were working with exotic materials.
Here is a place that can give better advice than I can.
Go to:
http://bbs.homeshopmachinist.net/
There are experts on the subject at that message board.
The General discussions link is:
http://bbs.homeshopmachinist.net/ubbs/forumdisplay.cgi?action=topics&forum=G
eneral&number=1&DaysPrune=45&LastLogin=
You'll get the exact answer you need there.
Marv
--
> From: mysticz28@swbell.net
> Reply-To: simpits-tech@simpits.org
> Date: Thu, 19 Sep 2002 21:43:50 -0500
> To: simpits-tech@simpits.org
> Subject: Re: [simpits-tech] High speed steel drill
>
> Marv De Beque wrote:
>>
>> Look at the chips you make. If they are long clean spirals, then it should
>> be fine. If they are blue and fracture easy, then it's too fast and hot.
>
> Of my chips are blue I have bigger problems ;) I have yet to turn
> aluminum blue with heat.
>
>> You are making too much of this in my opinion.
>
> Maybe, but when drilling titanium and magnesium I like to get it right
> the first time since the stuff is so damned expensive.
> --
> Steve
> mysticz28@swbell.net
> Jesus saves, Budda enlightens, Cthulhu thinks you'll make a nice
> sandwich.
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page.
> Thanks!