[simpits-tech] Marv... :)
lt1_z28@swbell.net
simpits-tech@simpits.org
Thu, 02 May 2002 16:29:09 -0500
Steve Wilson wrote:
>
> Have you considered R/C model car gearsets, Gene? I have no direct
> experience, but I remember going into a hobby shop once that specialized in
> these beasts and the wall was literally covered in aftermarket gears. Not
> sure you could find a rack there too, but it may be worth checking.
>
> Steve
>
> ----- Original Message -----
> From: "Gene Buckle" <geneb@deltasoft.com>
> To: <simpits-tech@simpits.org>
> Sent: Thursday, May 02, 2002 1:23 PM
> Subject: [simpits-tech] Marv... :)
>
> > Do you have a source for the slide or linear pots you *were* going to use?
> > I can't seem to find squat in the motion range I need. The rack & pinion
> > would be as expensive to do as the linear pots and they don't make a
> > pinion gear with a 1/4" bore (at least not from Small Parts).
> >
> > Thanks!
Check out allelectronics.com. They have a few gears, chains, pulleys,
belts, etc. If you can't find anything let me know and I'll make
something on the lathe.
--
Steve
lt1_z28@swbell.net http://www.mysticz28.org/
Jesus saves, Budda enlightens, Cthulhu thinks you'll make a nice
sandwich.