[simpits-tech] Computer Power Supplies

Marc Teichtahl simpits-tech@simpits.org
Wed, 12 Jun 2002 07:20:48 +0200


Hey gene,

There may be some that do. Im running many older style supplies that
rely on a simple switch and have no provision for power good to start.
But then the world is full of exceptions ;-)

-----Original Message-----
From: Gene Buckle [mailto:geneb@deltasoft.com] 
Sent: 11 June 2002 20:54
To: simpits-tech@simpits.org
Subject: RE: [simpits-tech] Computer Power Supplies


Actually Marc, they do.  At least the ones I have do.

g.


On Tue, 11 Jun 2002, Marc Teichtahl wrote:

> Or you can get an old AT style *not* ATX. These need no power good
> signal
>
> -----Original Message-----
> From: Ken Trager [mailto:kenamt@clt.bellsouth.net]
> Sent: 11 June 2002 20:02
> To: simpits-tech@simpits.org
> Subject: Re: [simpits-tech] Computer Power Supplies
>
>
> Thanks to Roy and Gene!!!!
>
> I just connected the black and the purple wire through a LED and it
> WORKS!
> Now I got a place to put a switch and a light to show it is working.
>
> Thanks - this is what Simpits is all about.
>
> Ken Trager
>
> > Hi Ken - you're right, some supplies do need a "power good" signal
> back
> > from the motherboard which can be bridged at the connector. I do
> recall
> > though that PC style switched-mode supplies MUST have a load on them
> at
> > all times.
>
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
> page.  Thanks!
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech@simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above
page.  Thanks!
>

_______________________________________________
Simpits-tech mailing list
Simpits-tech@simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above
page.  Thanks!