[simpits-tech] Stepper Controller V2.1
Erwin Neyt
simpits-tech@simpits.org
Mon, 18 Feb 2002 22:04:30 +0100
Looks good, Stig
About the photoprinting, can't you use a regular laser printer? Have you
experience with this. Just wondering.
I also did a similar design, but after I realised I was facing about 250 dig
inputs, 30 analogs, 170 dig outputs and 20 steppers, I am still figuring out
how to connect all those electronics to one or two pc's.
Any idea's on that?
Erwin.
> -----Original Message-----
> From: Stig Joergensen [mailto:stig.joergensen@clearsky.dk]
> Sent: maandag 18 februari 2002 19:21
> To: simpits-tech@simpits.org
> Subject: [simpits-tech] Stepper Controller V2.1
>
>
> Just get the board quoted - its gonna cost $100 in startup
> fee and then aprox $20 per board - so it looks like im doing
> a photoprint instead - on the hust for a used plotter.
>
>
> But I did it again.... swapped Vss (gnd) and Vdd (plus) so
> here is version 2.1
>
http://www.clearsky.dk/Electronics/StepControler/Schematics.gif
Http://www.clearsky.dk/Electronics/StepControler/Board.gif
Http://www.clearsky.dk/Electronics/StepControler/NetList.Txt
/Stig
P.S What a quiet weekend - what is happening?
> -----Original Message-----
> From: Gene Buckle [mailto:geneb@deltasoft.com]
> Sent: 18. februar 2002 06:14
> To: simpits-tech@simpits.org
> Subject: RE: [simpits-tech] Version 1 of the Stepper controler
>
>
> I'd make sure it works before you go to the expense of having a board
> mad.e :)
>
_______________________________________________
Simpits-tech mailing list
Simpits-tech@simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech