[simpits-tech] Resistor for LEDs?

[Joseph Fagner]

That's simple, don't really need to know the load, just use an free
molex connector from one of the systems running your simulator.  Your
computer will provide the load.  From this you could buy a small proto
board and make a simple circuit with and ground and power bus.

Jay


-----Original Message-----
From: simpits-tech-admin@simpits.org
[mailto:simpits-tech-admin@simpits.org] On Behalf Of Roy Coates
Sent: Tuesday, December 24, 2002 6:39 PM
To: simpits-tech@simpits.org
Subject: RE: [simpits-tech] Resistor for LEDs?



And if you're using a PC power supply, remember that it must have a
fairly
substantial load on it at all times to function correctly.

Can someone with a better memory than me remember HOW much of a load?

Roy.


_______________________________________________
Simpits-tech mailing list
Simpits-tech@simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above
page.  Thanks!