[simpits-tech] Angle off front console

[David C. Allen]

I also need the PR35X865 and they Quoted $205.ooUSD for a 10 foot length.

David
  www.737FlightSim.com

At 05:58 PM 12/9/2002 +0100, you wrote:
>Besides the PR35-1 there is also need for the T-shaped PR35X865 and a rail
>with a 78 deg angle PR35X780.
>
>I have somewhere a list with the exact lengths needed. Will have to dig
>though.
>
>Erwin.
>
> > -----Original Message-----
> > From: David C. Allen [mailto:allendc@qwest.net]
> > Sent: maandag 9 december 2002 17:02
> > To: simpits-tech@simpits.org
> > Subject: RE: [simpits-tech] Angle off front console
> >
> >
> > I just received a Quote for $90.ooUSD for 10' of Dzus PR35 rail. The
> > TP35AHT Dzus fastener install tool is around $240.ooUSD
> >
> > How many feet of PR35 is used in an F16?
> >
> > David
> > www.737FlightSim.com
> >
> > At 07:21 AM 12/9/2002 -0800, you wrote:
> >
> >
> > >On Mon, 9 Dec 2002, Erwin Neyt wrote:
> > >
> > > > BTW. How are the prices for DZUS in the States. Over here
> > they are
> > > > pretty high, because the local distributers order low qnty's. The
> > > > last time I informed they even had zero stock.
> > > >
> > > > Erwin.
> > > >
> > >The last time I checked, (5 years ago) they were $120 for a
> > single 10
> > >foot long section.
> > >
> > >g.
> > >
> > >
> > >_______________________________________________
> > >Simpits-tech mailing list
> > >Simpits-tech@simpits.org
> > >http://www.simpits.org/mailman/listinfo/simpits-tech
> > >To unsubscribe, please see the instructions at the bottom of
> > the above
> > >page.  Thanks!
> >
> > _______________________________________________
> > Simpits-tech mailing list
> > Simpits-tech@simpits.org
> > http://www.simpits.org/mailman/listinfo/simpit> s-tech
> > To
> > unsubscribe, please see the instructions at the
> > bottom of the above page.  Thanks!
> >
>
>_______________________________________________
>Simpits-tech mailing list
>Simpits-tech@simpits.org
>http://www.simpits.org/mailman/listinfo/simpits-tech
>To unsubscribe, please see the instructions at the bottom of the above 
>page.  Thanks!