[simpits-tech] Falcon 4.0 with motion sim

[Volker Metzger]

Hi Ken,
keep me informed if it works with the joystick and the extansion cable

volker

"Ken Trager" <kenamt@clt.bellsouth.net> schrieb:
> Volker
> 
> Thanks for saying that - i plug it up like you said and it did not work
> 
> So I must get a joystick extension cable - and hopefully it will
> 
> If not - maybe I fried the board - why can I get a replacement?
> 
> Thanks
> 
> KenTrager
> 
> > Hi Ken,
> > sorry i forgot to say you need a joystich extension cable and a
> > joystick for his test,
> >
> >
> >
> > 1. switch the rock mainboard to analog
> > 2. push a joystick direct into the rock mainboard joystick in/serial
> > in
> > 3. push the joystick extension cable in the rock mainboard joystick
> > extension in
> > 4. connect the other end of the joystick extension cable with the
> > gameport
> > 5. turn power on
> > 6. start compressor
> > 7. the rock must now move with the joystick movemnet,
> > if not we check the components
> > volker
> >
> >
> >
> >
> > "Volker Metzger" <Volker.Metzger@t-online.de> schrieb:
> > > Hi Ken,
> > > maybe this could be the fault but nevertheless try it with com1
> > before we do the next test
> > > volker
> > >
> > > "Ken Trager" <kenamt@bellsouth.net> schrieb:
> > > > Volker
> > > >
> > > > I do not have a Comm2 port - does this cause any problems?
> > > >
> > > > Ken Trager
> > > >
> > > > > 8. connect the seriell cable with the rock n ride"serial in" and
> > com2 off the computer
> > > > > start the compressor and the power on
> > > >
> > > >
> > > >
> > > > _______________________________________________
> > > > Simpits-tech mailing list
> > > > Simpits-tech@simpits.org
> > > > http://www.simpits.org/mailman/listinfo/simpits-tech
> > > > To unsubscribe, please see the instructions at the bottom of the
> > above page. Thanks!
> > > >
> > >
> > > _______________________________________________
> > > Simpits-tech mailing list
> > > Simpits-tech@simpits.org
> > > http://www.simpits.org/mailman/listinfo/simpits-tech
> > > To unsubscribe, please see the instructions at the bottom of the
> > above page. Thanks!
> > >
> >
>